CDC Wash Your Hands Bubbles School Bathroom Sign

Safely6ft.com™ repositionable graphics should be applied to a clean and dry surface. Ideal for a variety of smooth floor and wall surfaces such as marble, terrazzo, tile, sealed wood and sealed concrete, drywall and glass. Ambient temperature as well as surface temperature must be at least +50 ̊F to +86 ̊F (+10 ̊C to +30 ̊C). We recommend acclimating the graphics to the same application temperature for a few hours before beginning the application process. Use the supplied tape measure to install the floor graphics 6ft apart.

1. Use only mild soap and water to clean surface. Two drops of dish soap in one gallon of water is recommended as a cleaning solution. Do not use solvent-based cleansers, as the chemicals will interfere with the adhesive.For best performance, the surface must be completely free of grease and dust. After cleaning the surface needs to be dry. In order to dry the surface either use lint free cloths or other material without any particles on it.
2. Lift the upper edge of the liner and fold back approximate 8-12" down one edge, depending on the size of the graphics.
3. Carefully position your Safely6ft.comTM graphic so that it is properly aligned, then press exposed edge in place using light pressure.
4. Using your hand or supplied soft plastic squeegee, lightly press the film in place.
5. Working from the top of the graphic to the bottom, continue by peeling away more of the liner and applying light pressure to the film. Continue in this manner until the liner is completely removed and the graphic is in place.
6. Using your hand or supplied soft plastic squeegee, from center to all edges carefully push out any excess air bubbles. Finally, apply firm pressure to assure adhesion. Full tack will be achieved in 24-48 hours.

Note: For sensitive substrates, always test prior to application. Should not be applied to fresh paint.

Removal

Lift a corner of the material and pull slowly at an angle of approximately 45° to 75°. At an angle over 90° the adhesive is more likely to leave residue on the substrate. The temperature, along with the angle and speed at which you remove the vinyl, prevents adhesive residue or damage to occur to the application surface.

Materials

6.8 mil PET and PVC film laminated with non-slip 5 mil PVC textured laminate. UL-410 approved for slip resistance. Repositionable & washable adhesive. Scuff resistant.

Performance

Up to 1-year expected performance life for interior floors with proper installation and care.

Care

Use a cleaner designed for high-quality painted surfaces with a soft cloth. The cleaner must be wet, non-abrasive, without solvents, and have a pH value between 3 and 11 (neither strongly acidic nor strongly alkaline).